Knife for printing Honey-Super-L280

Knife for printing honeycomb 28 cm (Honey-Super-L280)

Before pumping honey, you need to remove the zabrus from the honey frames. Throughout the existence of beekeeping, many methods have been devised to remove wax lids from the framework: cutting, piercing, and steam. Each of these methods has its pros and cons. But most of all, the method of cutting lids using a knife is highlighted.

Using a knife, you coordinate your movements as much as possible, which is an undoubted plus. Knives also fall into several categories, cutting, steam, electric. Steam knives have good performance and significantly increase the speed of printing hundreds, but they have disadvantages. In addition to the need for a steam generator, which can be quite costly in terms of energy savings, working with a steam knife you risk getting a serious burn. Electric knives do an excellent job of removing wax lids, but they are tied to a power source, a light outage or a dead battery, can stop the process of preparing the frames for pumping honey.

The length of the blade is 28 centimeters. It is made of stainless steel. For convenience, sharpening on one side has special teeth on the sides, and on the other side a sharp blade.

The technology of sharpening the teeth eliminates the need to constantly undermine them, the blade will have a primary acuity after many cutting cycles of the prints. The end of the blade is bent upwards, this is done so that the knife does not engage the edges of the frame during operation. The knife is well balanced, so it sits perfectly in your hand. The handle is made of wood.

Such a knife will make you more mobile, easy to store, it does not require any power sources, heating steam or boiling water. Always ready to work, the performance is not inferior to elektronozham and others.

Country of origin: Czech Republic