Pasach electric knife Huslia 12V made of black (medical) steel

Pasach electric knife Huslia 12V made of black (medical) steel

To cut the seal, water was heated earlier and knives were heated in hot water. The water needed to be constantly maintained in a hot state and periodically heated knives. Thanks to modern technology, beekeepers are much quicker to cope with zabrusa.

One of the most successful inventions in this area has become a pasach elektronozh, which can be fed from a conventional car battery voltage of 12 volts. It is especially convenient to use for nomadic beekeepers. At the hospital, any voltage converter from 220 to 12 volts can be used. Thanks to the use of the Huslia knife, the beekeeper can several times accelerate and facilitate the process of preparing honey frames for pumping honey. A small power of a 25-watt electric elephant knife allows it to be heated up to 90 ° C and at the same time to economically use power supplies. A regular car battery with a capacity of 60A is enough for more than 28 hours of continuous operation of an electric knife.

Technical data of the product:

1. The dimensions of the knife blade: 2mm x 40mm x 230mm.
2. Power of the knife (voltage): 12 volts.
3. The temperature of the heated knife in working condition: 70-90 ° С.
4. The power of the electron-blade: 40 watts (on older models was 25 and 30 watts).
5. Temperature of the connected knife without use (in dry form): 100 ° C.
6. Time to prepare the knife to work (heating to 90 ° C): less than 1 minute (40-50 seconds).
7. Operating time of the knife during the working load: it is not limited (the knife does not require cooling).
8. The knife is made of black (medical) steel

Possible sources of electrical power for the knife:

• The shoe battery from the car 12 Volt;
• Charger car device 12 volts;
• The converter of voltage 220 / 12V.

Instructions for using an electric blade

Electronozh need to be connected to the power supply and after one minute it is ready for operation. In the hot working state, the temperature of the blade of the knife is approximately 90 ° C, but with a constant shearing off the honey frame, the temperature can drop to 70 ° C. When working hard, you need to periodically clean the blade of the knife. When working, the knife in the zabrus melts the wax and cools, so when preparing the frames, the knife needs to be placed on a wooden or iron stand. After use, the knife needs to be cleaned and dried. Store in a dry place without a sheath.

The knife is supplied in two versions:

•     From high-quality carbon steel (black)
•     Stainless steel for food products

To select the desired type of blade, select the desired option at the top of the page when ordering.

Manufacturer: Pasechny production and innovation cooperative "PAVIK", Ukraine.